Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Back Door Entry Lock Function does not Operate

for Preparation Click here


DESCRIPTION

If the back door entry lock function does not operate but the back door open function operates, the communication line between the vehicle and electrical key transmitter is normal. As a faulty part, the entry lock switch circuit (certification ECU (smart key ECU assembly) → back door opener switch (entry lock switch)) can be considered.

WIRING DIAGRAM


B171362E01


INSPECTION PROCEDURE

NOTICE:
Before performing the inspection, check that there are no problems related to "CAN COMMUNICATION SYSTEM" and "LIN COMMUNICATION SYSTEM".

1.CHECK POWER DOOR LOCK OPERATION
  1. When the door control switch on the master switch assembly is operated, check that the locked doors unlock (Click here).

    OK:
    Locked doors unlock.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM (Click here)
OK


2.READ VALUE ON TECHSTREAM (BACK DOOR OPENER SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus:
    Body Electrical / Smart Key / Data List.

  1. Select Tr/B-Door Lock SW in the Data List and read the Techstream display.

    Smart Key (Certification ECU (Smart Key ECU Assembly)): 
    Tester Display
    Measurement Item/Display
    Normal Condition
    Diagnostic Note
    Tr/B-Door Lock SW
    Back door lock switch / ON or OFF
    ON: Back door lock switch is pushed
    -
    OFF: Back door lock switch is not pushed

    OK:
    On the tester screen, each item changes between ON and OFF according to the chart above.



NG
Go to step 3
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)  

3.CHECK BACK DOOR OPENER SWITCH


    B171360E01
  1. Remove the back door opener switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock switch pushed
    Below 1 Ω
    1 - 2
    Lock switch not pushed
    10 kΩ or higher



NG
REPLACE BACK DOOR OPENER SWITCH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BACK DOOR OPENER SWITCH)


    B171361E01
  1. Disconnect the certification ECU (smart key ECU assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-7 (TSW5) - h1-1 (L)
    Always
    Below 1 Ω
    D40-7 (TSW5) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (BACK DOOR OPENER SWITCH - BODY GROUND)


    B164322E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    h1-2 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)