Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › ROOM TEMPERATURE SENSOR (for Rear)

ROOM TEMPERATURE SENSOR (for Rear) > INSPECTION

for Preparation Click here



1. INSPECT REAR ROOM TEMPERATURE SENSOR


E152647E01
  1. Remove the rear room temperature sensor .

  1. Disconnect the connector from the rear room temperature sensor.

  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N13-1 (+) - N13-2 (-)
    10°C (50°F)
    3.00 to 3.73 kΩ
    N13-1 (+) - N13-2 (-)
    15°C (59°F)
    2.45 to 2.88 kΩ
    N13-1 (+) - N13-2 (-)
    20°C (68°F)
    1.95 to 2.30 kΩ
    N13-1 (+) - N13-2 (-)
    25°C (77°F)
    1.60 to 1.80 kΩ
    N13-1 (+) - N13-2 (-)
    30°C (86°F)
    1.28 to 1.47 kΩ
    N13-1 (+) - N13-2 (-)
    35°C (95°F)
    1.00 to 1.22 kΩ
    N13-1 (+) - N13-2 (-)
    40°C (104°F)
    0.80 to 1.00 kΩ
    N13-1 (+) - N13-2 (-)
    45°C (113°F)
    0.65 to 0.85 kΩ
    N13-1 (+) - N13-2 (-)
    50°C (122°F)
    0.50 to 0.70 kΩ
    N13-1 (+) - N13-2 (-)
    55°C (131°F)
    0.44 to 0.60 kΩ
    N13-1 (+) - N13-2 (-)
    60°C (140°F)
    0.36 to 0.50 kΩ

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).
    If the resistance value is not as specified, replace the sensor.