REAR BRAKE > INSPECTION |
| 1. INSPECT BRAKE CYLINDER AND PISTON |
Inspect the cylinder bore and the piston for rust or scoring. If necessary, replace the rear disc brake cylinder assembly and piston.
| 2. INSPECT PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| 3. INSPECT NO. 1 REAR DISC BRAKE PAD SUPPORT PLATE |
Inspect the No. 1 rear disc brake pad support plate. If necessary, replace the No. 1 rear disc brake pad support plate.
| 4. INSPECT NO. 2 REAR DISC BRAKE PAD SUPPORT PLATE |
| 5. INSPECT DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| 6. INSPECT DISC RUNOUT |
![]() |
Using SST to hold the rear disc, tighten the rear disc with the 5 nuts.
![]() |
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.
Remove the 5 hub nuts and the rear disc.