Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

E111961E11

  1. Disconnect the 1A, 1F and 1M junction block connectors.

  2. Measure the voltage and resistance between the specified terminals of the wire harness side connectors and body ground.

    Standard voltage:

    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1A-1 - Body ground
    B - Body ground
    Battery power supply
    Always
    11 to 14 V


    Standard resistance:

    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1F-10 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1M-9 (GND2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the 1A, 1F and 1M junction block connectors.



  4. Measure the resistance and voltage between the specified terminals of the junction block connectors and body ground.

    Standard resistance:

    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D7-18 (CLTE)*1 - Body ground
    BR - Body ground
    Automatic light control ground
    Always
    Below 1 Ω


    Standard voltage:

    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1C-14 (PKB) - Body ground
    LG - Body ground
    Parking brake switch input
    Parking brake switch ON
    Below 1 V
    Parking brake switch OFF
    11 to 14 V
    1D-3 (HRLY) - Body ground
    P - Body ground
    Headlight relay drive output
    Light control switch in HEAD
    Below 1 V
    Light control switch not in HEAD
    11 to 14 V
    1D-9 (DRL*3/DIM*4) - Body ground
    L - Body ground
    High beam headlights drive output
    Dimmer switch in HIGH or HIGH FLASH
    Below 1 V
    Dimmer switch in LOW
    11 to 14 V
    1N-2 (HU) - Body ground
    LG - Body ground
    Dimmer switch HIGH input
    Dimmer switch in HIGH or HIGH FLASH
    Below 1 V
    Dimmer switch in LOW
    11 to 14 V
    1O-7 (LCTY) - Body ground
    B - Body ground
    Rear door courtesy switch LH input
    Rear door LH open
    Below 1 V
    Rear door LH closed
    11 to 14 V
    1P-5 (LSWL) - Body ground
    G - Body ground
    Rear door lock position switch LH input
    Rear door LH locked
    11 to 14 V
    Rear door LH unlocked
    Below 1 V
    1R-5 (ILE) - Body ground
    SB - Body ground
    Interior lights drive output
    Interior lights ON
    Below 1 V
    Interior lights OFF
    11 to 14 V
    D7-4 (MLRY)*2 - Body ground
    R - Body ground
    Door mirror foot light drive output
    Door mirror foot light ON
    Below 1 V
    Door mirror foot light OFF
    11 to 14 V
    D7-5 (LSWR) - Body ground
    B - Body ground
    Rear door lock position switch RH input
    Rear door RH locked
    11 to 14 V
    Rear door RH unlocked
    Below 1 V
    D7-7 (RCTY) - Body ground
    GR - Body ground
    Rear door courtesy switch RH input
    Rear door RH open
    Below 1 V
    Rear door RH closed
    11 to 14 V
    D7-17 (HEAD) - Body ground
    P - Body ground
    Light control switch HEAD input
    Light control switch in HEAD
    Below 1 V
    Light control switch not in HEAD
    11 to 14 V
    D7-19 (CLTS)*1 - Body ground
    G - Body ground
    Automatic light control sensor signal input
    Power switch off
    Below 1 V
    Automatic light control system operates
    Pulse generation
    (See waveform 1)
    D7-20 (CLTB)*1 - Body ground
    B - Body ground
    Automatic light control sensor power supply output
    Power switch off
    Below 1 V
    Power switch on (IG) and light control switch in AUTO
    11 to 14 V
    D7-21 (PCTY) - Body ground
    SB - Body ground
    Front passenger side door courtesy switch input
    Front passenger side door open
    Below 1 V
    Front passenger side door closed
    11 to 14 V
    D7-25 (BCTY) - Body ground
    L - Body ground
    Back door courtesy switch input
    Back door open
    Below 1 V
    Back door closed
    11 to 14 V
    D7-27 (LSWP) - Body ground
    SB - Body ground
    Front passenger side door lock position switch input
    Front passenger side door locked
    11 to 14 V
    Front passenger side door unlocked
    Below 1 V
    D7-28 (FFOG)*5 - Body ground
    O - Body ground
    Front fog light switch input
    Front fog light switch ON
    Below 1 V
    Front fog light switch OFF
    11 to 14 V
    D8-4 (FFGO) - Body ground
    O - Body ground
    Front fog light relay drive output
    Light control switch in HEAD and front fog light switch ON
    Below 1 V
    Front fog light switch OFF
    11 to 14 V
    D8-9 (LSWD) - Body ground
    GR - Body ground
    Driver side door lock position switch input
    Driver side door locked
    11 to 14 V
    Driver side door unlocked
    Below 1 V
    D8-13 (HF) - Body ground
    R - Body ground
    Dimmer switch HIGH FLASH signal input
    Dimmer switch in HIGH FLASH position
    Below 1 V
    Dimmer switch not in HIGH FLASH position
    11 to 14 V
    D8-21 (A) - Body ground
    G - Body ground
    Light control switch AUTO signal input
    Light control switch in AUTO
    Below 1 V
    Light control switch not in AUTO
    11 to 14 V
    D8-23 (TAIL) - Body ground
    SB - Body ground
    Light control switch TAIL signal input
    Light control switch in TAIL or HEAD
    Below 1 V
    Light control switch in neither TAIL nor HEAD
    11 to 14 V
    D8-24 (DCTY) - Body ground
    G - Body ground
    Driver side door courtesy switch input
    Driver side door open
    Below 1 V
    Driver side door closed
    11 to 14 V
    D8-25 (SWIL) - Body ground
    R - Body ground
    Engine switch illumination drive output
    Engine switch illumination ON
    11 to 14 V
    Engine switch illumination OFF
    Below 1 V

    If the result is not as specified, the main body ECU (Instrument panel junction block) may have a malfunction.

    HINT:
    *1: w/ Automatic Light Control
    *2: w/ Door Mirror Foot Light
    *3: w/ Daytime Running Light
    *4: w/o Daytime Running Light
    *5: w/ Front Fog Light




      B113714E01
    1. Waveform 1
      Item
      Contents
      Tool setting
      5 V/DIV., 5 ms./DIV.

      HINT:
      If the ambient light becomes brighter, width A becomes narrower.