CAN COMMUNICATION SYSTEM > Navigation Receiver Assembly Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Navigation Receiver Assembly Communication Stop Mode | "AVN" is not displayed on "CAN Bus Check" screen of Techstream |
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (NAVIGATION RECEIVER ASSEMBLY) |
![]() |
Disconnect the navigation receiver assembly connector (E4).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E4-2 (CANH) - E4-3 (CANL) | Power switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK POWER SOURCE CIRCUIT (NAVIGATION RECEIVER ASSEMBLY) |
Check the navigation receiver power source circuit (Click here).
|
| ||||
| OK | ||
| ||