Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › BLOWER MOTOR CONTROLLER (for Rear)

BLOWER MOTOR CONTROLLER (for Rear) > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.



2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure for the RH side and the LH side.



3. REMOVE DECK BOARD ASSEMBLY


    B173240
  1. Remove the deck board assembly.



4. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY


    B173242
  1. Disengage the 2 guides and remove the No. 3 deck board sub-assembly.



5. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY


    B173244
  1. Disengage the 2 guides and remove the No. 2 deck board sub-assembly.



6. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Remove the tonneau cover assembly.



7. REMOVE REAR SEAT SIDE COVER LH


    B173607
  1. Disengage the 2 clips and remove the rear seat side cover LH.



8. REMOVE DECK SIDE TRIM BOX LH


    B173243E01
  1. Remove the 2 deck side trim clips and clip.



  1. Remove the deck side trim box LH as shown in the illustration.


    B178554



9. REMOVE REAR SEAT SIDE COVER RH


    B173608
  1. Disengage the 2 clips and remove the rear seat side cover RH.



10. REMOVE JACK CARRIER SUPPORT


11. REMOVE JACK CARRIER CUSHION


    B178550
  1. Remove the jack carrier cushion.



12. REMOVE JACK ASSEMBLY


    B173245
  1. Remove the jack assembly.



13. REMOVE JACK CARRIER ASSEMBLY


    B178548
  1. Using a screwdriver, disengage the 3 claws and remove the jack carrier assembly.



14. REMOVE DECK SIDE TRIM BOX RH


    B173247E01
  1. Remove the 2 deck side trim clips and clip.



  1. Remove the deck side trim box RH as shown in the illustration.


    B178552



15. REMOVE REAR MAT


    B173249
  1. Remove the rear mat.



16. REMOVE DECK FLOOR BOARD ASSEMBLY


    B178561
  1. Disengage the 3 claws.

  1. Remove the 2 nuts and the deck floor board assembly.



17. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY


    B170935
  1. Remove the bolt and rear No. 2 seat inner belt assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



18. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH


    B170936
  1. Remove the bolt and disconnect the rear seat lap type belt assembly LH.



19. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.



20. REMOVE REAR NO. 2 SEAT ASSEMBLY


    B173781
  1. Remove the 4 bolts and the rear No. 2 seat assembly.



21. REMOVE REAR FLOOR FINISH PLATE


    B173609
  1. Disengage the 4 clips and the 4 claws, and remove the rear floor finish plate.



22. REMOVE REAR SEAT SIDE GARNISH CAP


    B173616
  1. Remove the screw.

  1. Disengage the 6 claws and the guide, and remove the rear seat side garnish cap.



23. REMOVE DECK SIDE TRIM COVER RH

HINT:
Use the same procedure for the RH side and the LH side.



24. REMOVE DECK SIDE TRIM RH

HINT:
Use the same procedure for the RH side and the LH side.



25. REMOVE SIDE TRIM COVER RH (for Manual Air Conditioning System)


    B173610
  1. Disengage the 4 claws and remove the side trim cover RH.



26. REMOVE REAR ROOM TEMPERATURE SENSOR (for Automatic Air Conditioning System)


    E150364
  1. Disengage the 4 claws and remove the rear room temperature sensor.

  1. Disconnect the connector.



27. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH


    B173618E01
  1. Using a screwdriver, disengage the 6 claws and the 2 guides, and remove the rear combination light service cover RH.

    HINT:
    Tape the screwdriver tip before use.



28. REMOVE ROPE HOOK ASSEMBLY (for RH Side)

HINT:
Use the same procedure for the RH side and the LH side.



29. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

HINT:
Use the same procedure for the No. 1 luggage compartment trim hook and the No. 2 deck side trim hook.



30. REMOVE FRONT DECK SIDE TRIM COVER RH

HINT:
Use the same procedure for the RH side and the LH side.



31. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Remove the 3 bolts.

  1. Remove the 2 clips.



  1. Disengage the 7 claws and 4 clips, and remove the deck trim side panel assembly RH.


    B173622



32. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.



33. REMOVE BLOWER MOTOR CONTROLLER


    E150361
  1. Disconnect the connector.

  1. Remove the 2 screws and the blower motor controller.