Home › BODY ELECTRICAL › OTHER SYSTEM › CLOCK SYSTEM

CLOCK SYSTEM > Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit is the power source for the clock assembly. This circuit provides two types of power sources; one is a constant power source mainly used as a backup power source, and the other is a power source mainly used for signal transmission.

HINT:
If the clock assembly displays "1:00" when the power switch off, then on (READY) again, the +B terminal has a malfunction.
The maximum clock assembly margin of error is -4 to 4 seconds per day when the temperature is between -20°C (-4°F) and 60°C (140°F).


WIRING DIAGRAM


E152379E07


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR


    E146936E01
  1. Disconnect the E11 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E11-6 (+B) - Body ground
    Always
    11 to 14 V
    E11-1 (IG) - Body ground
    Power switch on (READY)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E11-5 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CLOCK ASSEMBLY (Click here)