Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Read the DTCs by following the directions on the tester screen.

    HINT:
    Refer to the Techstream operator's manual for further details.


CLEAR DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Erase the DTCs by following the directions on the tester screen.

    HINT:
    Refer to the Techstream operator's manual for further details.