Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here


HINT:
The following items can be customized.

NOTICE:
  1. After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
  2. Be sure to record the current settings before customization.
  3. When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to "OFF", then perform troubleshooting).


CUSTOMIZE
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Customize Setting /

  5. Select the setting by referring to the table below.

    Power back door system 
    Display (Item)
    Default
    Function
    Setting
    PBD SW Operation
    0.8 s
    Function that turns power back door closer switch ON when switch is pushed once or held down for 0.8 sec.
    0.8s / ON
    PBD Buzzer
    ON
    This function makes the power back door buzzer sound when power back door is operating
    ON / OFF
    Wirels PBD SW Operation
    0.8 s
    Function that operates power back door when transmitter switch is pressed in specified way
    ON / 2 times / 0.8 s / OFF