AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > Rear Air Conditioning Control Panel Circuit |

| 1.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING CONTROL - BODY GROUND) |
![]() |
Disconnect the R1 rear air conditioning control connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R1-10 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING CONTROL - BATTERY) |
![]() |
Disconnect the R1 rear air conditioning control connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| R1-10 (E) - R1-2 (IG+) | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - REAR AIR CONDITIONING CONTROL) |
![]() |
Disconnect the R1 control connector.
Disconnect the D38 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D38-13 (RLIN) - R1-5 (MPX-) | Always | Below 1 Ω |
| D38-13 (RLIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE REAR AIR CONDITIONING CONTROL |
Replace the rear air conditioning control .
| NEXT | |
| 5.CHECK REAR AIR CONDITIONING CONTROL (OPERATION) |
Operate the rear air conditioning control to check that it functions properly.
|
| ||||
| OK | ||
| ||