DTC B1447/47 Rear Air Mix Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1447/47 | Rear air mix damper position does not change even if air conditioning amplifier operates rear air mix control servo motor. |
|

| 1.READ VALUE USING TECHSTREAM (AIR MIX PULSE-R) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and turn the Techstream main switch on.
Select the item below in the Data List, and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Servo Targ Pulse(R) | Rear air mix control servo motor target pulse / Min.: 0, Max.: 255 | MAX. COLD: 9 (pulse) MAX. HOT: 54 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE) | B |
| OK (When troubleshooting according to DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the N12 rear air conditioning harness connector.
Disconnect the D38 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N12-2 (RBUG) - D38-21 (RBUG) | Always | Below 1 Ω |
| N12-3 (RBUS) - D38-1 (RBUS) | Always | Below 1 Ω |
| N12-4 (RBBU) - D38-23 (RBBU) | Always | Below 1 Ω |
| D38-21 (RBUG) - Body ground | Always | 10 kΩ or higher |
| D38-1 (RBUS) - Body ground | Always | 10 kΩ or higher |
| D38-23 (RBBU) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE REAR AIR MIX CONTROL SERVO MOTOR |
Replace the rear air mix control servo motor (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||