DTC B1449/49 Rear Air Outlet Damper Control Servo Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1449/49 | Rear air outlet damper position does not change even if air conditioning amplifier operates rear air outlet damper control servo motor. |
|

| 1.READ VALUE USING TECHSTREAM (AIR OUT PULSE-R) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and turn the Techstream main switch on.
Select the items below in the Data List, and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Outlet Servo Pulse(R) | Rear air outlet control servo motor target pulse / Min.: 0, Max.: 255 | Rr FACE: 83 (pulse) Rr B/L: 38 (pulse) Rr FOOT: 7 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE) | B |
| OK (When troubleshooting according to DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (REAR AIR CONDITIONING HARNESS - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the N12 rear air conditioning harness connector.
Disconnect the D38 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N12-2 (RBUG) - D38-21 (RBUG) | Always | Below 1 Ω |
| N12-3 (RBUS) - D38-1 (RBUS) | Always | Below 1 Ω |
| N12-4 (RBBU) - D38-23 (RBBU) | Always | Below 1 Ω |
| D38-21 (RBUG) - Body ground | Always | 10 kΩ or higher |
| D38-1 (RBUS) - Body ground | Always | 10 kΩ or higher |
| D38-23 (RBBU) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE REAR AIR OUTLET CONTROL SERVO MOTOR |
Replace the rear air outlet control servo motor.
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||