AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver |

| 1.INSPECT RADIO RECEIVER |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E14-7 (MCVD) - Body ground | Power switch on (ACC) | 4 to 6 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER) |
![]() |
Disconnect the microphone connector and the radio receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q11-1 (ACC) - E14-7 (MCVD) | Always | Below 1 Ω |
| Q11-3 (MI1+) - E14-2 (MIC+) | Always | Below 1 Ω |
| Q11-5 (MIC-) - E14-1 (MIC-) | Always | Below 1 Ω |
| E14-3 (TSW-) - E14-6 (MGND) | Always | Below 1 Ω |
| Q11-1 (ACC) - Body ground | Always | 10 kΩ or higher |
| Q11-3 (MI1+) - Body ground | Always | 10 kΩ or higher |
| Q11-5 (MIC-) - Body ground | Always | 10 kΩ or higher |
| E14-3 (TSW-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||