Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR OPENER / CLOSER SWITCH

POWER BACK DOOR OPENER / CLOSER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER BACK DOOR OPENER / CLOSER SWITCH


B165199E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 1
    Pushed (ON)
    Below 1 Ω
    4 - 1
    Free (OFF)
    10 kΩ or higher

    If the result is not as specified, replace the switch.

  1. Check that the switch illuminates.

    Standard resistance:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 3 (ILL+)
    Battery negative (-) → 2 (ILL-)
    Illuminates

    If the result is not as specified, replace the switch.