Home › BODY › ENGINE HOOD / DOOR › FUEL LID OPENER MOTOR ASSEMBLY

FUEL LID OPENER MOTOR ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL LID MOTOR ASSEMBLY


    B178862E01
  1. Apply battery voltage to the lock control and check the motor operates in the open direction.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor operates and shaft moves in open direction

    If the result is not as specified, replace the fuel lid opener motor assembly.

  1. Check the shaft stroke.

    Standard:
    10.3 mm (0.406 in.) or more

    If the result is not as specified, replace the fuel lid opener motor assembly.