Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the overhead junction block (microphone) to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the overhead junction block (microphone).

WIRING DIAGRAM


E147390E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (OVERHEAD JUNCTION BLOCK - NAVIGATION RECEIVER ASSEMBLY)


    E153685E01
  1. Disconnect microphone connector Q11 and navigation receiver assembly connector E4.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q11-1 (ACC) - E4-17 (MACC)
    Always
    Below 1 Ω
    Q11-3 (MI1+) - E4-19 (MIC+)
    Always
    Below 1 Ω
    Q11-5 (MIC-) - E4-20 (MIC-)
    Always
    Below 1 Ω
    E4-17 (MACC) - Body ground
    Always
    10 kΩ or higher
    E4-19 (MIC+) - Body ground
    Always
    10 kΩ or higher
    E4-20 (MIC-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E153730E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E4-17 (MACC) - Body ground
    Power switch on (ACC)
    4 to 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY)


    E141024E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-12 (TSW-) - E4-18 (SGND)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)