Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0AE2-773    Hybrid Battery Precharge Contactor Circuit Stuck Closed

for Preparation Click here


DESCRIPTION

Refer to the description for DTC P0AE6-225 (Click here).

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0AE2
773
SMR1 on the HV battery positive side stuck closed
HV relay assembly

WIRING DIAGRAM

See the wiring diagram of P0AE6-225 .

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals. After waiting for 5 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.

HINT:
  1. Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.
  2. If P0AE2-773 is output, the vehicle is prevented from starting.

1.CHECK HV RELAY ASSEMBLY

CAUTION:
Be sure to wear insulated gloves.

  1. Turn the power switch off.



    A108057E07
  1. Remove the service plug grip (Click here).

    NOTICE:
    After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    z30-1 - j2-1
    Power switch off
    10 kΩ or higher

    HINT:
    1. If a system main relay is stuck closed, inspect the HV relay assembly without removing it from the vehicle, in order to keep the relay closed.
    2. If P0AE2-773 is output, the HV relay assembly must be replaced. Measuring resistance can determine if this is either a present or past malfunction.
    3. If the resistance is between 28.5 and 31.5 Ω, it can be determined that SMR1 is stuck closed.



NG
REPLACE HV RELAY ASSEMBLY (Click here)
OK

REPLACE HV RELAY ASSEMBLY (Click here)