Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The television display assembly sends a sound signal to the radio receiver through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM


E158432E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY ASSEMBLY)


    E152223E04
  1. Disconnect the radio receiver and the television display assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q13-28 (R+) - E16-2 (CDR+)
    Always
    Below 1 Ω
    Q13-29 (R-) - E16-3 (CDR-)
    Always
    Below 1 Ω
    Q13-30 (L+) - E16-4 (CDL+)
    Always
    Below 1 Ω
    Q13-31 (L-) - E16-5 (CDL-)
    Always
    Below 1 Ω
    Q13-27 (SG1) - E16-1 (CSLD)
    Always
    Below 1 Ω
    Q13-28 (R+) - Body ground
    Always
    10 kΩ or higher
    Q13-29 (R-) - Body ground
    Always
    10 kΩ or higher
    Q13-30 (L+) - Body ground
    Always
    10 kΩ or higher
    Q13-31 (L-) - Body ground
    Always
    10 kΩ or higher
    Q13-27 (SG1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E152224E01
  1. Reconnect the television display assembly connector.

  1. Check the waveform according to the conditions shown in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    Q13-28 (R+) - Body ground
    Disc changer sound is being produced
    A waveform synchronized with sound is output
    Q13-29 (R-) - Body ground
    Disc changer sound is being produced
    A waveform synchronized with sound is output
    Q13-31 (L-) - Body ground
    Disc changer sound is being produced
    A waveform synchronized with sound is output
    Q13-30 (L+) - Body ground
    Disc changer sound is being produced
    A waveform synchronized with sound is output



NG
REPLACE TELEVISION DISPLAY ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)