AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Television Display Assembly |

| 1.INSPECT RADIO RECEIVER |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-6 (MUTE) - Body ground | Turn power switch on (ACC), RSE system is playing → Mode is changing | Above 3.5 V → Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY ASSEMBLY) |
![]() |
Disconnect the radio receiver and the television display assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-6 (MUTE) - Q13-26 (LMUT) | Always | Below 1 Ω |
| E16-6 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT TELEVISION DISPLAY ASSEMBLY |
![]() |
Reconnect the television display assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Q13-26 (LMUT) - Body ground | Turn power switch on (ACC) | Above 3.5 V |
|
| ||||
| OK | ||
| ||