Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B173224
  1. Disengage the 8 claws and guide, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B173227
  1. Remove the clip.

  1. Disengage the clip and claw, and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B173021
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 claws and 10 clips.



    B173009
  1. Disconnect each connector and the aspirator duct.

  1. Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



4. REMOVE BRAKE PEDAL RETURN SPRING


    C170605
  1. Remove the brake pedal return spring from the push rod pin and instrument panel reinforcement.



5. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E150073
  1. Disconnect the connector.



    E150074E01
  1. Loosen the stop light switch lock nut and remove the stop light switch assembly.



6. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin, and separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.



7. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C171424
  1. Disconnect the sensor connector.



    C171425
  1. Remove the 2 bolts and brake pedal stroke sensor.

    NOTICE:
    Do not drop the sensor. If the sensor has been dropped, replace the brake pedal stroke sensor with a new one.



8. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    C171316
  1. Disconnect the connector and disengage the clamp.



    C165373
  1. Remove the 2 bolts and separate the brake pedal support sub-assembly from the instrument panel reinforcement.



    C176476
  1. Remove the 4 nuts and brake pedal support sub-assembly from the body.