Home › BODY › ENGINE HOOD / DOOR › BACK DOOR

BACK DOOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR PANEL SUB-ASSEMBLY


  1. Check that the clearance measurements of areas A through M are within each standard range.


    B172919E01


    Standard clearance:

    Area
    Measurement
    Area
    Measurement
    A
    7.8 to 11.8 mm (0.307 to 0.465 in.)
    I
    4.0 to 8.0 mm (0.158 to 0.315 in.)
    B
    -3.0 to 0.5 mm (-0.118 to 0.020 in.)
    J
    (for Glass Hatch Type:)
    2.0 to 3.5 mm (0.079 to 0.138 in.)
    C
    7.8 to 11.8 mm (0.307 to 0.465 in.)
    J
    (for Fixed Glass Type:)
    2.5 to 3.0 mm (0.098 to 0.118 in.)
    D
    -3.0 to 0.5 mm (-0.118 to 0.020 in.)
    K
    (Height is 1930mm (75.984 in.) or more:)
    4.0 to 7.0 mm (0.158 to 0.276 in.)
    E
    7.8 to 11.8 mm (0.307 to 0.465 in.)
    K
    (Height is 1930mm (75.984 in.) below:)
    3.5 to 6.5 mm (0.138 to 0.256 in.)
    F
    -3.0 to 0.5 mm (-0.118 to 0.020 in.)
    L
    4.0 to 8.0 mm (0.158 to 0.315 in.)
    G
    7.8 to 11.8 mm (0.307 to 0.465 in.)
    M
    4.5 to 8.5 mm (0.177 to 0.335 in.)
    H
    -3.0 to 0.5 mm (-0.118 to 0.020 in.)
    -
    -