Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B1273    Sliding Roof ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is output when LIN communication between the sliding roof ECU (sliding roof drive gear) and main body ECU (instrument panel junction block assembly) stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1273
No communication between sliding roof drive gear and main body ECU (instrument panel junction block assembly) for more than 10 seconds
  1. Sliding roof ECU (Sliding roof drive gear sub-assembly)
  2. Main body ECU (Instrument panel junction block assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B176995E08


INSPECTION PROCEDURE

NOTICE:
When using Techstream with the power switch off to troubleshoot:
Connect Techstream to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF ECU)


    B172349E03
  1. Disconnect the D9 connector.

  1. Disconnect the Q12 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D9-10 (LIN2) - Q12-4 (MPX1)
    Always
    Below 1 Ω
    Q12-4 (MPX1) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D9-10 (LIN2) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)


    B164448E03
  1. Disconnect the Q12 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q12-2 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q12-1 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
  1. Replace the sliding roof ECU (sliding roof drive gear sub-assembly) with a normally-functioning or a new one (Click here).

  1. Delete the DTC.


NEXT


4.CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B1273 is not output
    A
    B1273 is output
    B



B
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
A

END