Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

NOTICE:
  1. Using Techstream to read the DATA LIST allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.
  2. In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the power switch off.

  3. Connect Techstream to the DLC3.

  4. Turn the power switch on (IG).

  5. Turn the tester on.

  6. Enter the following menus.

    1. Techstream - Select: Body Electrical / Body / Main body / Data List /

  7. According to the display on the tester, read the "Data List".

    Main Body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Communication D-Door Motor
    Connection status between power window regulator motor (for driver side) and main body ECU / OK or STOP
    OK: Connection
    DTC is output if an error occurs in LIN communication
    Communication Slide Roof
    Connection status between Sliding Roof ECU and main body ECU / OK or STOP
    OK: Connection
    DTC is output if an error occurs in LIN communication
    Communication Smart / Wireless
    Connection status between certification ECU and main body ECU / OK or STOP
    OK: Connection
    DTC is output if an error occurs in LIN communication