Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B2786    No Response from Steering Lock ECU

for Preparation Click here


DESCRIPTION

This DTC is output when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B2786
No communication between steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for more than 10 seconds
  1. Steering lock ECU (Steering lock actuator assembly)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B156210E19


INSPECTION PROCEDURE

NOTICE:
When using Techstream with the power switch off to troubleshoot:
Connect Techstream to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)


    B164470E03
  1. Disconnect the D40 connector.

  1. Disconnect the D11 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-10 (LIN) - D11-5 (LIN)
    Always
    Below 1 Ω
    D40-10 (LIN) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D40-10 (LIN) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY)


    B177001E02
  1. Disconnect the D11 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D11-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D11-7 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY)
  1. Replace the steering lock ECU (steering lock actuator assembly) with a normally-functioning or a new one (Click here).

  1. Delete the DTC.


NEXT


4.CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B2786 is not output
    A
    B2786 is output
    B



B
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
A

END