Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B2321    Driver Side Door ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is output when LIN communication between the front power window regulator motor assembly LH and main body ECU (instrument panel junction block assembly) stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B2321
No communication between front power window regulator motor assembly LH and main body ECU (instrument panel junction block assembly) for more than 10 seconds
  1. Front power window regulator motor assembly LH
  2. Main body ECU (Instrument panel junction block assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B176995E09


INSPECTION PROCEDURE

NOTICE:
When using Techstream with the power switch off to troubleshoot:
Connect Techstream to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - FRONT POWER WINDOW REGULATOR MOTOR LH)


    B177000E01
  1. Disconnect the D9 connector.

  1. Disconnect the H1 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D9-10 (LIN2) - H1-9 (LIN)
    Always
    Below 1 Ω
    D9-10 (LIN2) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D9-10 (LIN2) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B176994E01
  1. Disconnect the H1 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    H1-1 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    H1-2 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
  1. Replace the front power window regulator motor assembly LH with a normally-functioning or a new one (Click here).

  1. Delete the DTC.


NEXT


4.CHECK FOR DTC
  1. Recheck for DTC.

    Result:
    Result
    Proceed to
    B2321 is not output
    A
    B2321 is output
    B



B
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
A

END