Home › BODY › ENGINE HOOD / DOOR › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


  1. Check operation of the opener switch.



      B178891E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      2 - 3
      Back door opener switch not pushed (OFF)
      10 kΩ or higher
      2 - 3
      Back door opener switch pushed (ON)
      Below 1 Ω

      If the result is not specified, replace the back door opener switch assembly.



  1. Check operation of the lock switch (w/ Smart Key System).



      B171360E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      1 - 2
      Back door lock switch not pushed (OFF)
      10 kΩ or higher
      1 - 2
      Back door lock switch pushed (ON)
      Below 1 Ω

      If the result is not specified, replace the back door opener switch assembly.