Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY


    E144461E12
  1. Check the LO operation.

    1. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (E), and check that the motor operates at low speed (LO).

      OK:
      Motor operates at low speed (LO).

  1. Check the HI operation.

    1. Connect the battery's positive (+) lead to terminal 3 (+2) and the negative (-) lead to terminal 4 (E), and check that the motor operates at high speed (HI).

      OK:
      Motor operates at high speed (HI).



  1. Check the automatic stop operation.

    1. Put the matchmark on the windshield wiper motor assembly.

    2. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (E). With the motor rotating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the matchmark.

    3. Using SST, connect terminals 1 (+S) and 5 (+1). Then connect the battery's positive (+) lead to terminal 2 (B) and the negative (-) lead to terminal 4 (E) to restart the motor operation at low speed (LO).

      SST
      09843-18040  



    4. E147815E04
    5. Check that the motor stops automatically at the matchmark.

      OK:
      Motor stops automatically at the matchmark.

      If the result is not as specified, replace the motor assembly.