WIPER SWITCH > INSPECTION |
| 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
Check the front wiper switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D17-1 (+S) - D17-3 (+1) | INT | Below 1 Ω |
| OFF | ||
| D17-2 (+B) - D17-3 (+1) | MIST | |
| LO | ||
| D17-2 (+B) - D17-4 (+2) | HI |
Check the front washer switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D18-2 (EW) - D18-3 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
Check the intermittent operation.
Connect the voltmeter's positive (+) lead to terminal D17-3 (+1) and the negative (-) lead to terminal D18-2 (EW).
Connect the battery's positive (+) lead to terminal D17-2 (+B) and the negative (-) lead to terminal D18-2 (EW) and D17-1 (+S).
Turn the wiper switch to the INT position.
Connect the battery's positive (+) lead to terminal D17-1 (+S) for 5 seconds.
Connect the battery's negative (-) lead to terminal D17-1 (+S). Operate the intermittent wiper relay and check the voltage between terminals D17-3 (+1) and D18-2 (EW).

Check the front washer operation.
Turn the wiper switch OFF.
Connect the battery's positive (+) lead to terminal D17-2 (+B) and the negative (-) lead to terminals D17-1 (+S) and D18-2 (EW).
Connect the voltmeter's positive (+) lead to D17-3 (+1) and the negative (-) lead to terminal D18-2 (EW).
Turn the washer switch ON and OFF, and check the voltage between terminals D17-3 (+1) and D18-2 (EW).

![]() |
Check the rear wiper switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D18-2 (EW) - D18-6 (C1R) | LO | Below 1 Ω |
| D18-2 (EW) - D18-7 (+1R) | HI | |
| D18-2 (EW) - D18-6 (C1R) | OFF | 10 kΩ or higher |
| D18-2 (EW) - D18-7 (+1R) |
Check the rear washer switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D18-2 (EW) - D17-5 (WR) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |