WIRELESS DOOR LOCK BUZZER > INSTALLATION |
| 1. INSTALL WIRELESS DOOR LOCK BUZZER |
![]() |
Connect the connector.
Install the wireless door lock buzzer with the clamp.
| 2. INSTALL FRONT FENDER LINER LH |
![]() |
Install the front fender liner LH with the 5 clips and 8 screws.
![]() |
Install 2 new grommets.
Using a 4 mm hexagon wrench, install the 2 screws.
![]() |
Install the screw and pin hold clip.
| 3. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH |
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the front fender side protector from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
![]() |
Clean the front fender moulding sub-assembly. (If reusing the front fender moulding sub-assembly)
Using a heat light, heat the front fender moulding sub-assembly.
Remove the front fender side protector from the front fender moulding sub-assembly.
Wipe off any tape adhesive residue with cleaner.
Install a new front fender side protector to the the front fender moulding sub-assembly.
Install 2 new No. 4 clips on the front fender moulding sub-assembly.
Install a new pad on the front fender moulding sub-assembly.
![]() |
Install the front fender moulding sub-assembly.
Using a heat light, heat the vehicle body and the front fender moulding sub-assembly.
Remove the release paper from the front fender moulding sub-assembly.
Engage the 3 clips and install the front fender moulding sub-assembly.
![]() |
Using a 4 mm hexagon wrench, install the screw.
Install the clip.
| 4. INSTALL NO. 1 ENGINE UNDER COVER |
Install the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.