Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REASSEMBLY

for Preparation Click here



1. INSTALL COOLER DRYER


    E153506
  1. Using pliers, install the cooler dryer to the modulator.



    E101932
  1. Apply sufficient compressor oil to an O-ring and the cap fitting surface.

    Compressor oil:
    ND-OIL 11 or equivalent

    NOTICE:
    1. Keep the O-rings and O-ring fitting surfaces clean from dirt or any foreign objects.
    2. Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.



    E153505E01
  1. Using a 14 mm straight hexagon wrench, install the cap to the cooler condenser core.

    Torque:
    2.9 N*m{ 30 kgf*cm , 26 in.*lbf }