Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > REASSEMBLY

for Preparation Click here



1. CONNECT WASHER HOSE ASSEMBLY


    B172910
  1. Connect the washer hose assembly.



2. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle sub-assembly so that the washer fluid spray area is as specitied.


    E150188E01



3. INSTALL WASHER NOZZLE SUB-ASSEMBLY


    E128831
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    B163611E01
  1. Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.



4. INSTALL HOOD INSULATOR


    B172909
  1. Install the hood insulator with the 8 clips.



5. INSTALL HOOD TO RADIATOR SUPPORT SEAL


    B172907
  1. Install the hood to radiator support seal with the 8 clips.



6. INSTALL RADIATOR SEAL SUB-ASSEMBLY
  1. Clean the vehicle body surface.

    1. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from the radiator seal sub-assembly.

    HINT:
    After removing the release paper, keep the exposed adhesive free from foreign matter.



    B177263
  1. Install a new radiator seal sub-assembly with the 2 clips.

  1. Install the 6 clips.



7. INSTALL FRONT HOOD PROTECTOR


    B172908
  1. Engage the 4 claws and install the front hood protector.



8. INSPECT FRONT WASHER NOZZLE SUB-ASSEMBLY


  1. With the engine running, check the positions that the washer fluid hits the windshield.


    E150189E01

    Area
    Dimension
    A
    353 mm (13.88 in.)
    B
    143 mm (5.70 in.)
    C
    193 mm (7.61 in.)

    OK:
    Washer fluid hits the windshield in the areas shown in the illustration.

    HINT:
    If the result is not as specified, replace the washer nozzle.