Home › ENGINE › 3MZ-FE EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL
  1. Remove the 11 clips and cool air intake duct seal.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A173489
  1. Remove the 2 bolts, 4 clamps and air cleaner cap sub-assembly.

  1. Remove the air cleaner filter element from the air cleaner case sub-assembly.



3. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.



4. REMOVE NO. 2 ENGINE UNDER COVER
  1. Remove the 4 bolts and No. 2 engine under cover.



5. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A176012
  1. Remove the 4 bolts and 4 compression springs.

  1. Disconnect the 3 exhaust pipe supports, and then remove the center exhaust pipe assembly and 2 gaskets.



6. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY


    A176010
  1. Disconnect the oxygen sensor connector.

  1. Remove the 2 bolts, 2 nuts, front No. 3 exhaust pipe sub-assembly and the 2 gaskets.



7. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A176013
  1. Remove the 3 bolts and the No. 1 exhaust manifold heat insulator.



8. REMOVE MANIFOLD STAY


    A176007
  1. Remove the bolt, nut, and the manifold stay.



9. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
  1. Disconnect the air fuel ratio sensor connector.



    A176014
  1. Remove the 6 nuts and the exhaust manifold sub-assembly RH.

  1. Remove the exhaust manifold gasket.



10. REMOVE AIR FUEL RATIO SENSOR (for Bank 1)
  1. Disconnect the air fuel ratio sensor connector and clamp.



    A173500E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly RH.

    SST
    09224-00010  

    NOTICE:
    Do not damage the air fuel ratio sensor.



11. REMOVE NO. 3 MANIFOLD CONVERTER INSULATOR


    A176015
  1. Remove the bolt, nut, and the No. 3 manifold converter insulator.



12. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A176016
  1. Remove the 2 bolts and the No. 2 exhaust manifold heat insulator.



13. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A176011
  1. Disconnect the oxygen sensor connector.

  1. Remove the 2 nuts, front exhaust pipe assembly and gasket.



14. REMOVE AIR FUEL RATIO SENSOR (for Bank 2)
  1. Disconnect the air fuel ratio sensor connector and clamp.



    A173498E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly LH.

    SST
    09224-00010  

    NOTICE:
    Do not damage the air fuel ratio sensor.



15. REMOVE NO. 2 EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    A176017
  1. Remove the bolt, 6 nuts, and the No. 2 exhaust manifold convertor sub-assembly.

  1. Remove the exhaust manifold gasket.