Home › ENGINE › 3MZ-FE LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A085603E04
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A176036
  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.



    A176034
  1. Connect the oil pressure switch connector.



2. INSPECT FOR OIL LEAK


3. INSTALL FRONT FENDER APRON SEAL RH


    A108741
  1. Install the fender apron seal RH with the 2 bolts and clip.



4. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }