Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0AF8-816    Hybrid Battery System Voltage

for Preparation Click here


DESCRIPTION


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0AF8
816
Low HV battery voltage
  1. Hybrid control system
  2. HV battery

MONITOR DESCRIPTION

If the battery smart unit detects an abnormal drop in HV battery voltage, the hybrid vehicle control ECU will turn on the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0AF8 (INF 816): Battery voltage abnormal lowering
Required sensors / components
HV battery assembly
Frequency of operation
-
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Battery smart unit
DTC P0AF8 (INF 816) is not detected

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    DTCs other than P0AF8-816, P3000-388, and P3000-389 are not output.
    A
    DTCs other than P0AF8-816, P3000-388, and P3000-389 are output.
    B



B
GO TO DTC CHART (Click here)
A


2.CHECK ENGINE START
  1. Turn the power switch on (READY).

  1. Check if the engine starts.

    HINT:
    Depressing the accelerator pedal with the shift lever in the P position will cause the engine to start.

    Result:
    Result
    Proceed to
    The engine starts.
    A
    The engine does not start.
    B



B
REPLACE HV BATTERY (Click here)
A

LEAVE VEHICLE IN P POSITION, AND CHARGE HV BATTERY BY IDLING UNTIL IDLING STOPS