Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › IGCT RELAY

IGCT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT IGCT RELAY


    A032779
  1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the IGCT relay.