Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › INTEGRATION RELAY

INTEGRATION RELAY > INSPECTION

for Preparation Click here



1. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY



A173537E01

  1. Inspect the EFI No. 1 fuse.

    1. Remove the EFI No. 1 fuse.

    2. Using an ohmmeter, measure the resistance of the fuse.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      EFI No. 1 fuse
      Always
      Below 1 Ω

  1. Inspect the A/F fuse.

    1. Remove the A/F fuse.

    2. Using an ohmmeter, measure the resistance of the fuse.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      A/F fuse
      Always
      Below 1 Ω



  1. Inspect the C/OPN relay.



      A172481E04
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      2E-13 - 2E-6
      No battery voltage applied
      10 kΩ or higher
      2E-13 - 2E-6
      Battery voltage applied to terminals 2E-6 and 2D-12
      Below 1 Ω

      NOTICE:
      While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.



  1. Inspect the A/F relay.



      A172481E05
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      2A-4 - 2C-1
      No battery voltage applied
      10 kΩ or higher
      2A-4 - 2C-1
      Battery voltage applied to terminals 2E-10 and 2E-6
      Below 1 Ω

      NOTICE:
      While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.