COOLING SYSTEM (for Inverter) > ON-VEHICLE INSPECTION |
| 1. INSPECT FOR COOLANT LEAK (for Inverter) |
Remove the reserve tank cap.
![]() |
Install the radiator cap tester.
Pump the radiator cap tester to 37 kPa (0.38 kgf/ cm2, 5.4 psi), and then check that the pressure does not drop.
Reinstall the reserve tank cap.
| 2. INSPECT COOLANT LEVEL IN RESERVE TANK (for Inverter) |
The coolant should be between the LOW and FULL lines when the coolant for the inverter is cold.
| 3. INSPECT COOLANT (for Inverter) |
Remove the reserve tank cap.
Check for excessive deposits of rust or scale on and around the reserve tank cap and its opening.
Reinstall the reserve tank cap.
| 4. INSPECT RESERVE TANK CAP (for Inverter) |
![]() |
Inspect the reserve tank cap.
If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.
Check that the O-ring is not deformed, cracked, or damaged.
Check that the O-ring is not swollen.
![]() |
Check the reserve tank cap operation.
Apply coolant (for inverter) to the O-ring and rubber packing before using a radiator cap tester.
Install the reserve tank cap to the radiator cap tester.
Pump the cap tester several times, and check the maximum pressure.
| Standard value (for brand-new cap) | 15 to 44 kPa (0.15 to 0.45 kgf/cm2, 2.18 to 6.38 psi) |
| Minimum standard value (for used cap) | 12 kPa (0.12 kgf/cm2, 1.74 psi) |
| Pump speed | 1 pump per second |