Home › BODY › EXTERIOR › FENDER LINER (for Front Side)

FENDER LINER (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.



2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH


    B172795
  1. Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.



    B172796
  1. Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.



    B172797E01
  1. Remove the front fender side protector from the front fender moulding sub-assembly.



3. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:
Use the same procedures for the RH side and LH side.



4. REMOVE FRONT WHEEL OPENING EXTENSION PAD (for LH Side)


    B174748
  1. Remove the 2 screws and front wheel opening extension pad.



5. REMOVE FRONT WHEEL OPENING EXTENSION PAD (for RH Side)

HINT:
Use the same procedure for the RH side and LH side.



6. REMOVE FRONT FENDER LINER LH


    B175996E01
  1. Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    B174749
  1. Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.



    B174751
  1. Remove the 5 clips, 8 screws and front fender liner LH.



7. REMOVE FRONT FENDER LINER RH


    B174753E01
  1. Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    B174750
  1. Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.



    B174752
  1. Remove the 5 clips, 7 screws and front fender liner RH.