FENDER LINER (for Rear Side) > INSTALLATION |
| 1. INSTALL REAR WHEEL HOUSE LINER LH |
![]() |
Install the rear wheel house liner LH with the 10 clips.
| 2. INSTALL REAR WHEEL HOUSE LINER RH |
![]() |
Install the rear wheel house liner RH with the 10 clips.
| 3. INSTALL REAR BUMPER SIDE SEAL LH |
![]() |
Install 2 new grommets.
Install the rear bumper side seal LH with the clip, bolt and screw.
| 4. INSTALL REAR BUMPER SIDE SEAL RH |
| 5. INSTALL QUARTER PANEL SEAL LH |
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Quarter Panel Seal | 20 to 30°C (68 to 86°F) |
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
![]() |
Install a new quarter panel seal LH.
Using a heat light, heat the vehicle body and a new quarter panel seal LH.
Remove the release paper from the quarter panel seal LH.
Install the quarter panel seal LH with the 4 screws.
| 6. INSTALL QUARTER PANEL SEAL RH |
| 7. INSTALL REAR WHEEL HOUSE PAD LH |
![]() |
Install the rear wheel house pad LH with the 3 screws.
| 8. INSTALL REAR WHEEL HOUSE PAD RH |