Home › BODY › EXTERIOR › SIDE MUDGUARD

SIDE MUDGUARD > REMOVAL

for Preparation Click here


HINT:
When removing the side mudguard, heat the vehicle body and side mudguard using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Side Mudguard
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or side mudguard excessively.



1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY


    B172795
  1. Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.



    B172796
  1. Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.



    B172797E01
  1. Remove the front fender side protector from the front fender moulding sub-assembly.



2. REMOVE FRONT FENDER OUTSIDE MOULDING PAD


    B172798E01
  1. Remove the front fender outside moulding pad from the front fender moulding sub-assembly.



3. REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY


    B172799
  1. Turn back the front door weatherstrip.

  1. Remove the nut.



    B172800E01
  1. Peel off the upper front door outside moulding pad and disengage the 11 clips, and then remove the front door outside moulding sub-assembly.

  1. Remove the gasket from the front door outside moulding sub-assembly.

  1. Remove the 3 No. 3 clips from the front door outside moulding sub-assembly.

  1. Remove the 8 No. 4 clips from the front door outside moulding sub-assembly.



    B172801E01
  1. Remove the upper front door outside moulding pad from the front door outside moulding sub-assembly.



4. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY


    B172802
  1. Turn back the rear door No. 2 weatherstrip.

  1. Remove the nut.



    B172803E01
  1. Peel off the upper rear door outside moulding pad and disengage the 8 clips, and then remove the rear door outside moulding sub-assembly.

  1. Remove the gasket from the rear door outside moulding sub-assembly.

  1. Remove the 2 No. 3 clips from the rear door outside moulding sub-assembly.

  1. Remove the 6 No. 4 clips from the rear door outside moulding sub-assembly.



    B172804E01
  1. Remove the upper rear door outside moulding pad from the rear door outside moulding sub-assembly.