Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER MOTOR (for Front Side)

WASHER MOTOR (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    B181107
  1. Remove the 11 clips and cool air intake duct seal.



3. REMOVE RADIATOR GRILLE


    B181108E01
  1. Put protective tape around the radiator grille.



    B181109
  1. Remove the 2 bolts and 4 clips.



    B181110
  1. Disengage the 6 claws and 4 guides, and remove the radiator grille.



4. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)


    B172760E01
  1. Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172761E01
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172763
  1. Remove the 7 screws and clip.



    B172764
  1. Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.



5. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)


    B172760E01
  1. Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172761E01
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172763
  1. Remove the 7 screws and clip.



    B172764
  1. Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each fog light connector, and then remove the front bumper assembly.



6. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:
Use the same procedures for the RH side and LH side.



7. REMOVE FRONT FENDER LINER RH


    B174753E01
  1. Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    B174750
  1. Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.



    B174752
  1. Remove the 5 clips, 7 screws and front fender liner RH.



8. DRAIN WASHER FLUID


    E150185
  1. Disconnect the washer hose from the front washer motor and pump assembly, and drain the washer fluid.



9. REMOVE FRONT WASHER MOTOR AND PUMP ASSEMBLY


    E150186E02
  1. Disconnect the connector.

  1. Remove the front washer motor and pump assembly.