Home › RESTRAINTS › SEAT BELT › FRONT PASSENGER SEAT BELT WARNING LIGHT

FRONT PASSENGER SEAT BELT WARNING LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)


2. INSTALL NO. 2 RADIO BRACKET (w/ Navigation System)


    E150547
  1. Install the No. 2 radio bracket with the 6 screws.



3. INSTALL NO. 1 RADIO BRACKET (w/ Navigation System)


    E150548
  1. Install the No. 1 radio bracket with the 6 screws.



    E150546
  1. Engage the claw and connect the connector.



4. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Navigation System)


    B170950
  1. Engage the 2 clips and install the integration control and panel assembly.



    E151584
  1. Engage the claw and connect the connector.



5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
  1. Connect each connector.



    E150545
  1. Engage the 4 clips.



    E150544
  1. Install the navigation receiver assembly with bracket with the 4 bolts.



6. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)
  1. Connect each connector.



    E150552
  1. Engage the 4 clips.



    E150551
  1. Install the radio receiver assembly with bracket with the 4 bolts.



7. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)


    E150368
  1. Disengage the 4 clips and remove the heater control and accessory assembly.

  1. Disconnect the connector.



8. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
  1. Connect the connector.



    E150367
  1. Engage the 4 clips and install the air conditioning control assembly.



9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B184681E01
  1. Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.



10. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY


    B168369
  1. Engage the 2 claws and 5 clips, and install the center instrument panel register assembly.