Home › SECURITIES › ENGINE IMMOBILISER › CERTIFICATION ECU

CERTIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


    B170919
  1. Install the certification ECU (smart key ECU assembly) with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connectors.



2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector and clamp.



    B168370
  1. Engage the 4 claws and 3 clips.

  1. Install the lower instrument panel sub-assembly with the 2 bolts <B> and 3 screws <E>.



3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B173000
  1. Engage the 2 guides.

  1. Engage the 3 claws and install the No. 2 instrument panel under cover sub-assembly.



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side .



5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and LH side .



6. REGISTER ECU COMMUNICATION ID

NOTICE:
When replacing the certification ECU (smart key ECU assembly), perform initialization (Click here).



7. REGISTER KEY

NOTICE:
When replacing the certification ECU (smart key ECU assembly), perform initialization (Click here).