Home › BODY ELECTRICAL › DOOR LOCK › ENTRY LOCK AND UNLOCK SWITCH (for Back Door)

ENTRY LOCK AND UNLOCK SWITCH (for Back Door) > INSPECTION

for Preparation Click here



1. INSPECT ENTRY LOCK SWITCH (for Back Door)


    B171360E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock switch pushed
    Below 1 Ω
    1 - 2
    Lock switch not pushed
    10 kΩ or higher

    If the result is not specified, replace the entry lock switch.