POWER WINDOW MASTER SWITCH > INSPECTION |
| 1. INSPECT POWER WINDOW MASTER SWITCH |
Check that the switch function.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (U) - 1 (E) - 4 (A) | Auto UP (Driver side) | Below 1 Ω |
| 8 (U) - 1 (E) | Manual UP (Driver side) | Below 1 Ω |
| 5 (D) - 1 (E) | Manual DOWN (Driver side) | Below 1 Ω |
| 4 (A) - 5 (D) - 1 (E) | Auto DOWN (Driver side) | Below 1 Ω |
| 6 (B) - 16 (U) 15 (D) - 1 (E) | UP (Passenger side) | Below 1 Ω |
| 6 (B) - 15 (D) 16 (U) - 1 (E) | DOWN (Passenger side) | Below 1 Ω |
| 6 (B) - 12 (U) 13 (D) - 1 (E) | UP (Rear LH) | Below 1 Ω |
| 6 (B) - 13 (D) 12 (U) - 1 (E) | DOWN (Rear LH) | Below 1 Ω |
| 6 (B) - 10 (U) 18 (D) - 1 (E) | UP (Rear RH) | Below 1 Ω |
| 6 (B) - 18 (D) 10 (U) - 1 (E) | DOWN (Rear RH) | Below 1 Ω |
Check that the LED illuminates.
![]() |
Apply battery voltage to the master switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 (LED) Battery negative (-) → Terminal 1 (E) | LED illuminates |