BACK WINDOW LOCK > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE BACK WINDOW UPPER TRIM PANEL ASSEMBLY |
![]() |
Disengage the 4 clips and 4 claws, and remove the back window upper trim panel assembly.
| 3. REMOVE BACK DOOR TRIM COVER LH (w/o Power Back Door) |
![]() |
Disengage the 2 clips and 2 claws, and remove the back door trim cover LH.
| 4. REMOVE BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door) |
![]() |
Disengage the 6 claws, and remove the back door service hole cover LH.
| 5. DISCONNECT POWER BACK DOOR ROD (w/ Power Back Door) |
![]() |
Disconnect the power back door rod and remove the back door stay plate.
| 6. REMOVE BACK DOOR TRIM COVER LH (w/ Power Back Door) |
![]() |
Disengage the 2 clips and 2 claws, and remove the back door trim cover LH.
| 7. REMOVE BACK DOOR TRIM COVER RH |
![]() |
Disengage the 2 clips and 2 claws, and remove the back door trim cover RH.
| 8. REMOVE BACK DOOR LOCK COVER (for Glass Hatch Type) |
![]() |
Disengage the 2 claws and 4 guides, and remove the back door lock cover.
| 9. REMOVE ASSIST STRAP HOLE COVER |
![]() |
Disengage the 2 claws and 2 guides, and remove the assist strap hole cover.
| 10. REMOVE ASSIST STRAP ASSEMBLY |
![]() |
Remove the bolt and assist strap assembly.
| 11. REMOVE BACK DOOR TRIM PANEL ASSEMBLY |
![]() |
Disengage the 16 clips and remove the back door trim panel assembly.
| 12. REMOVE REAR WIPER SHAFT COVER |
![]() |
Disengage the 3 clips and remove the rear wiper shaft cover.
| 13. REMOVE REAR WIPER ARM HEAD CAP |
![]() |
Remove the rear wiper arm head cap.
| 14. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY |
![]() |
Remove the nut and the rear wiper arm and blade assembly.
| 15. REMOVE REAR WIPER LINK CAP |
![]() |
Remove the rear wiper link cap.
| 16. REMOVE REAR WIPER LINK PIVOT |
![]() |
Remove the nut and the rear wiper link pivot.
| 17. REMOVE REAR WIPER MOTOR ASSEMBLY |
When reinstalling the rear wiper motor assembly :
Open the glass hatch.
![]() |
Engage the 3 claws and 2 guides, and then install the centering jig.
![]() |
Close the glass hatch, and engage the 2 claws and guide.
![]() |
Disconnect the connector.
Remove the 2 nuts.
Remove the 4 bolts and the rear wiper motor assembly.
When using a new rear wiper motor assembly:
![]() |
Disconnect the connector.
Remove the 4 bolts.
![]() |
Remove the 2 nuts and the rear wiper motor assembly.
| 18. REMOVE BACK WINDOW LOCK ASSEMBLY |
![]() |
Disconnect the connector.
Disengage the clamp.
![]() |
Remove the 3 bolts.
![]() |
Disengage the clip and remove the back window lock assembly.