Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO RECEIVER

RADIO RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY


    B168368E01
  1. Apply protective tape to the areas shown in the illustration.

  1. Using a moulding remover, disengage the 2 claws and 5 clips, and then remove the center instrument panel register assembly as shown in the illustration.



2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    B184680E01
  1. Apply protective tape to the areas shown in the illustration.

  1. Using a moulding remover, disengage the 10 claws and 8 clips starting from the upper part of the center instrument cluster finish panel assembly.

    NOTICE:
    Do not pull on the small storage compartment lid. Doing so may cause damage.

  1. Disconnect each connector and remove the center instrument cluster finish panel assembly.



3. REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)


    E150368
  1. Disengage the 4 clips and remove the heater control and accessory assembly.

  1. Disconnect the connector.



4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)


    E150367
  1. Disengage the 4 clips and remove the air conditioning control assembly.

  1. Disconnect the connector.



5. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    E150551
  1. Remove the 4 bolts.



    E150552
  1. Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.

  1. Disconnect each connector and remove the radio receiver assembly with bracket.



6. REMOVE NO. 1 RADIO BRACKET


    E150546
  1. Disengage the claw and remove the connector.



    E150554
  1. Remove the 5 screws and No. 1 radio bracket.



7. REMOVE NO. 2 RADIO BRACKET


    E150553
  1. Remove the 5 screws and No. 2 radio bracket.



8. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    E151584
  1. Disengage the claw and disconnect the connector.



    B170938
  1. Disengage the 2 clips and remove the integration control and panel assembly.



9. REMOVE RADIO RECEIVER ASSEMBLY