Home › BODY ELECTRICAL › AUDIO / VISUAL › BACK DOOR SPEAKER

BACK DOOR SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR STEREO COMPONENT SPEAKER

HINT:
Remove interior parts so that the rear stereo component speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the rear stereo component speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the rear stereo component speaker.



  1. Speaker resistance check



      E147418E03
    1. Disconnect the rear stereo component speaker connector.

    2. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Tester connection
      Condition
      Specified condition
      1 (WF+) - 2 (WF-)
      Always
      1.6 to 2.4 Ω
      4 (WF+) - 3 (WF-)
      Always
      1.6 to 2.4 Ω

      NOTICE:
      The speaker should not be removed when checking resistance.

      If the result is not as specified, replace the rear stereo component speaker.