Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH


  1. Disconnect the steering pad switch assembly connector.


    E136177E08

  1. Measure the resistance according to the values in the table below.

    Standard resistance:

    Tester connection
    Condition
    Specified condition
    AU1 - EAU
    No switch is pushed
    Approx. 100 kΩ
    AU1 - EAU
    SEEK+ switch: push
    0 to 2.5 Ω
    AU1 - EAU
    SEEK- switch: push
    Approx. 0.3 kΩ
    AU1 - EAU
    VOL+ switch: push
    Approx. 1 kΩ
    AU1 - EAU
    VOL- switch: push
    Approx. 3.1 kΩ
    AU2 - EAU
    No switch is pushed
    Approx. 100 kΩ
    AU2 - EAU
    MODE switch: push
    0 to 2.5 Ω
    AU2 - EAU
    VOICE switch: push (*1)
    Approx. 3.1 kΩ
    AU2 - EAU
    ON HOOK switch: push (*2)
    Approx. 0.3 kΩ
    AU2 - EAU
    OFF HOOK switch: push (*2)
    Approx. 1 kΩ

    *1: w/ Navigation System
    *2: for Premium models
    If the result is not as specified, replace the steering pad switch.