Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT LEVEL WARNING SWITCH ASSEMBLY


    E152498E01
  1. Remove the washer jar.

  1. Disconnect the level warning switch connector.

    HINT:
    The check should be performed with the level warning switch assembly installed to the washer jar.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SLR1) - 2 (E)
    Washer jar is full
    10 kΩ or higher
    1 (SLR1) - 2 (E)
    Washer jar is empty
    Below 1 Ω

    If the result is not as specified, replace the level warning switch assembly.